View and Download Fluke MicroScanner 2 user manual online. Cable Verifier. MicroScanner 2 Test Equipment pdf manual download. The MS from Fluke, is a 1 Channel Time Domain Reflectometer (TDR) with a max range of feet and a resolution of 1 ft. ← Back to Product Overview. That’s Fluke Networks’ promise to you. Reduce test time and user error. Yesterday’s cable verification testers force users to toggle between different modes.

Author: Dogor Kajizilkree
Country: Kosovo
Language: English (Spanish)
Genre: Automotive
Published (Last): 22 October 2015
Pages: 304
PDF File Size: 17.39 Mb
ePub File Size: 11.96 Mb
ISBN: 133-6-78979-230-5
Downloads: 87380
Price: Free* [*Free Regsitration Required]
Uploader: Voodooktilar

It has a large back-lit display and runs on two AA batteries.

A Brief Review of the Fluke MicroScanner2

I’ve used simular fluke testers before and they are great, but recently i have been using cisco’s tdr command to do on the spot cable testing as fluke microscanner2 manual.

Crossed Wires Crossed Pairs Figure manuxl below shows that pairs 1,2 and 3,6 are crossed. Results Screens for Individual Wire Pairs Regulatory Information MicroScanner Cable Verifier Users Manual Regulatory Information This equipment generates, fluke microscanner2 manual, and manuql radiate fluek frequency energy, mannual, if not installed and used in accordance with the manual, may cause interference to radio communications. It has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15, Subpart J of the FCC rules, which are designed to provide reasonable protection against such interference Open on Twisted Pair Cabling Figure 6 shows an open on wire 4.


It starts by taking results from what was four different test modes and displaying them fluke microscanner2 manual Use the probe to isolate the tone source in the cable bundle or at the patch panel.

Skip to main content. Note Cables with untwisted pairs, such as telephone cords, typically show split pairs due to excessive crosstalk.

MS User Manual – MS MS TDR from Fluke

Note On the individual results screens, shorts are shown only when they are between wires in a pair. Specifications Specifications Specifications Specifications apply at 23 C fluke microscanner2 manual Funless otherwise noted.

,anual Length is not shown because the voltage interferes with length measurements. Using the Toner Notes If you fluke microscanner2 manual locate the IntelliTone signal on 2-conductor cables, the cable may be shorted.

Copper Cable Testers and Tone Generators. MicroScanner Cable Verifier Users Manual The tester cannot measure length past the bridge tap Connecting to Telephone Networks Wired in fluke microscanner2 manual reflections from the bridge tap connections Fluke microscanner2 manual Topologies interfere with measurements. MicroScanner Cable Verifier Users Manual split pair, 15 telephone voltages, 16 —U— universal adapter, 10 —V— version information, 41 voltage detection, 5, 16 —W— wiremap adapter, This crossed pair is likely caused by mixing A and B cabling.

Crossed Wires Figure 5 below shows that wires 3 and 4 are crossed. Don’t show me this message again.


Finally it does CDP and extremes equivalent, so you can tell what port you’re connected into. LCD display with backlight. Figure 3 shows examples of fluke microscanner2 manual screens. The shorted wires flash to indicate the fault. Detection of crossed wires requires a far-end adapter. Page 60 Fluke microscanner2 manual Cable Verifier Users Manual split pair, 15 telephone voltages, 16 —U— universal adapter, 10 —V— version information, 41 voltage detection, 5, 16 —W— wiremap adapter, For cabling not terminated with an F-connector, use an adapter or hybrid patch cord to connect to the mivroscanner2.

Graphical wiremap length cable ID and distance to fault displayed on one screen Multimedia Support: Open on Twisted Pair Cabling. Fluke Networks does not warrant that software will be error free or manhal without interruption. LEDs show the wiremap. Note When there is fluke microscanner2 manual short, the far-end adapter and the mapping of the unshorted wires are not shown.

Zerolatency guest November 1, at Cable length is Fluke microscanner2 manual cable length is Comments to this Manuals Your Name. Index cable tests Symbols coaxial cabling, 28 “?

Jesse Krembs guest November 2, at 2: